 crank bolt, loose? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| doobie123 |
 Jun 27 2023, 10:44 AM
Post
#1
|
|
Member  Group: Members Posts: 86 Joined: 8-July 22 From: tucson Member No.: 26,683 Region Association: Southwest Region  |
working on my porsche 914, 2.0, 5 spd
i'll try to keep this short and still give the details so... i had the drive train out to do the clutch/flywheel and decided to freshen the top end. the car ran fine when i got it but, the clutch was bad so i took the plunge,(something i never did before) and went for it. put it back together and test drove it. it ran fine for the first mile or so but on my way back to the shop, it started making a banging or, knocking noise. i decided to check the valves and use the method of pulling the plugs and turning the cage by hand. pulled the plugs, went to turn the cage and it was loose. i was able to rock it and when i turned it, the cage turned but not the three bolts holding it. upon further inspection, i was able to turn the center bolt, (crank bolt?) with my fingers. i got a socket, (13mm) on it and can tighten it down but before it tightened, i could feel a clicking through the wrench. so my questions are does it just tighten on the cage? should there be a key way that the cage needs to engage? will tightening it the torque specks do the trick or do i need to drop the engine again? is there a chance i've done damage by running it? i know that there is a unknown as far as the damage but i'm just looking for some suggestions as to where i go from here. thanks |
   |
 
|
  |
Replies
| Olympic 914 |
Jun 27 2023, 10:55 AM
Post
#2
|
|
Group: Members Posts: 1,707 Joined: 7-July 11 From: Pittsburgh PA Member No.: 13,287 Region Association: North East States 
|
There is a keyway there.
Timing is set by marks on the fan, so it HAS to be in the correct spot to start with. Otherwise you will never get the timing set right. |
|
|
|
Posts in this topic
doobie123 crank bolt Jun 27 2023, 10:44 AM
r_towle There is a woodruff key on the end of the crank th... Jun 27 2023, 10:53 AM r_towle Looking at another thread..
You used the crank bol... Jun 27 2023, 11:04 AM
doobie123
Looking at another thread..
You used the crank bo... Jun 27 2023, 11:14 AM doobie123 ok, so i spoke to dr. 914 and he suggested to tigh... Jun 27 2023, 12:17 PM r_towle Take the fan off.
Take a closer look.
If all part... Jun 27 2023, 12:43 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd November 2024 - 10:52 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.