 Treating inner long, what to use |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| spunone |
 Jan 24 2005, 04:06 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 945 Joined: 6-April 04 From: Anaheim CA Member No.: 1,901 Region Association: Southern California  |
Ok another Dumb question .Cut out rust on top of rear long in the Hell Hole .Inside of long is'nt too bad so I vac out now what before I weld it up.Spray a rust killer or some type of primer or nothing at all,Whats been done by you pros .Thanks again.Sorry to be such a pain
|
   |
 
|
  |
Replies
| MarkV |
Jan 24 2005, 05:34 PM
Post
#2
|
|
Fear the Jack Stands Group: Members Posts: 1,493 Joined: 15-January 03 From: Sunny Tucson, AZ Member No.: 154 Region Association: None |
I just went through this on mine. Vacuum out the long & then put some Synco-Ospho in a spray bottle & spray it in there liberally. Let it dry overnight & then spray the whole area with zinc primer. Let that dry & then top coat it with rustoleum. I took the spray nozzle & extension tube off a can of carb cleaner & used it on the primer & rustoleum cans. Once the long is close up no water should be able to get in to cause more problems.
|
|
|
|
Posts in this topic
spunone Treating inner long Jan 24 2005, 04:06 PM
r_towle if you can get a rust stopper in there, doit.
Use... Jan 24 2005, 05:16 PM 9146986 This is the same post I made a few weeks ago, when... Jan 24 2005, 05:33 PM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 23rd November 2024 - 08:31 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.