Front Sidemarker Flasher Module Options

[Spoke]

There has been some interest in a module that would flash the front sidemarker with the turnsignal. The rear running/brake/turnsignal board I did for the 356 using the front turnsignal bucket from a 914 uses the same function to flash the running or brake light when the turnsignal comes on.

The flashing circuit was lifted from the 356 board and placed on this board with some modification. The board will be about 1.6in x 1in and will be enclosed in a small plastic box. The module will replace the wires which go from the front trunk into the rubber wire channel to the sidemarker and turnsignal.

Basically the wires to the turnsignal and sidemarker will be pulled out of the rubber channel and connected to the module. The module will have wires that will be fished into the rubber channel and connected to the sidemarker and turnsignal just like the OEM wiring. The OEM wiring will remain intact keeping with my goal of no cutting/screwing/gluing plug-and-play installation.


@Cairo94507

[Spoke]

This is the assembly for one side. The module has wires on both sides. One side goes to the vehicle wires pulled out of the conduit and the other side goes to the new wires going in the conduit. The connectors on the vehicle side are female and on the turnsignal side are male so it cannot be reversed.

The spades to the sidemarker do not have insulation like OEM to make it easier to fish through the sidemarker gasket.