2270 Build thread, Looking forward to making all of the mistakes! Options

[vjb206]

Hey folks! I've got...

• Case halves from an old 1.7 (cleaned as best I could)
• 2270 crank + P&C kit
• #163/86b Web Cam
• 2.0 heads with 44X36 valves, where I'll be installing dual springs and 38mm exhaust valves
• Upgraded oil pump and other goodies

So my first question for the community has to do with ensuring the rotating mass is spinning freely/correctly…

I started by measuring all of the the main journals on the crank and I got a range from 2.358” - 2.360” (I used a digital caliper and I'm pretty sure I did this correctly).

Then I “dry-fit” Silverline STD/STD main bearings into the case (sans crank), torqued everything down, and got 0.003” in radial play (I used a cylinder bore dial gauge for the first time, and I think I did it correctly).

The spec-sheet says radial play should be between 0.06” - 0.10” (0.03” - 0.09” for #2); and I have 0.003." I'm a MINIMUM of 0.057" off, is that normal? What's my next step?

1. Stop pretending I know what I'm doing and take it to a machinist for test-fitting and honing (I'd like to keep cost down so this is my less preferred option)
2. DIY: hone 0.06" off all bearings (what's the right honing tool / approach here?)
3. Order different bearings (if so, which?)

[Eric_Ciampa]

First time engine builder here. Building a 2270 and I am about at the same spot. Got most of the parts. Working on oil galley plugs and sending parts off for balancing. Was reading Tom Wilson’s book and came across this section on using plastigage.