 Ground Points, Bare Metal Base Disk |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DennisV |
  Jul 14 2024, 08:29 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 565 Joined: 8-August 20 From: Santa Rosa, CA Member No.: 24,575 Region Association: Northern California 
 |
Would I be correct in thinking that the metal disk where ground studs are located should be bare metal?
The one in this photo is above the relay board in the engine bay. It was painted body color and I stripped it with a wire brush. I just can't imagine that thick disk behind the stud was meant to be covered in paint if that is a ground location.  P.S. After tightening these connections, is it good practice to coat them in dielectric grease? P.P.S. Are the ground point locations the same on the 914-6 as the 914-4s? @JeffBowlsby had a nice drawing of the locations, but I think it was specific to the 4s. |
   |
 
|
Posts in this topic
bdstone914 Yes they need bare metal. The grease can't hur... Jul 14 2024, 08:44 AM technicalninja The grease HELPS bigtime!
Doesn't really ... Jul 14 2024, 10:35 AM technicalninja If my car wasn't a real live six, I'd add ... Jul 14 2024, 10:40 AM Superhawk996 Dielectric = non conductive
Dielectric grease do... Jul 14 2024, 11:31 AM technicalninja :agree: :agree: :agree:
However, I've used... Jul 14 2024, 11:44 AM
Superhawk996
:agree: :agree: :agree:
However, I've use... Jul 14 2024, 12:04 PM 930cabman I have shied away from greases with electrical con... Jul 15 2024, 11:25 AM  |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 12:22 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.