 Help - Installing CV/Axle Assemblies after Engine Install? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Tom1394racing |
 Oct 29 2024, 02:59 PM
Post
#1
|
|
Member  Group: Members Posts: 376 Joined: 25-August 07 From: CT Member No.: 8,039 Region Association: North East States  |
On my -6 GT project I decided to leave the CV/axle installation until after the engine was installed. I figured there has to be a way to change out the CV/axle assembly with the engine in the car.
This afternoon, I went to install them with the stub axle installed on the CV. It was not clear that they would fit. It seemed like I might need to remove the heat exchanger and/or the shock absorber. Any tricks to this? Do I need to install the stub axles before the CV/axle assembly? I can't imagine that I need to remove the engine to install the CV/axles. How is this done? |
   |
 
|
  |
Replies
| bdstone914 |
Oct 29 2024, 07:48 PM
Post
#2
|
|
bdstone914 Group: Members Posts: 4,696 Joined: 8-November 03 From: Riverside CA Member No.: 1,319 |
No need to remove the heat exchangers. Remove the lower shock bolt and let the trailing arm come down about 4 inches to get clearance to install the assemblies.
Floor jack to raise up the trailing arm. |
|
|
|
Posts in this topic
Tom1394racing Help - Installing CV/Axle Assemblies after Engine Install? Oct 29 2024, 02:59 PM
Tom1394racing Well, I’ve done a little bit of reading on this ... Oct 29 2024, 07:04 PM technicalninja Have you had the car aligned yet?
If not, I'd... Oct 29 2024, 07:20 PM rgalla9146 Bolts out of lower shocks with some way to both lo... Oct 29 2024, 08:50 PM Tom1394racing Thanks for all your suggestions. I'll try the ... Oct 30 2024, 07:01 AM Tom1394racing Did the passenger side today. I removed the shock ... Oct 30 2024, 04:57 PM
Tom1394racing I did the driver's side today. I only needed t... Oct 31 2024, 02:17 PM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 1st November 2024 - 04:18 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.