 Fuel pump relocation and wiring |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| captjm |
 Nov 22 2024, 09:03 PM
Post
#1
|
|
Newbie  Group: Members Posts: 8 Joined: 28-January 07 From: Temecula, CA Member No.: 7,485  |
I need some help with wiring a 914 fuel pump being relocated to the front fuel tank location exactly like the 75/76 914's. The car is a 1971 914/4 being set up for a carbureted 2.4 six cylinder. My question is about where to pick up the power to run the pump correctly.
I would like it to have any relay protections like the original if that is the way it is suppose to be. I think the positive power is to come from the engine compartment relay board from the forward connector pin 13? I plan on running the positive wire from pin 13 under the driver side rocker panel forward to to the fuel tank bay and picking up the ground from the closest grounding point nearest to the tank bay. Any comments or advice would be helpful. Thank you |
   |
 
|
  |
Replies
| dtmehall |
Nov 24 2024, 07:00 PM
Post
#2
|
|
Member Group: Members Posts: 64 Joined: 21-December 23 From: Farmington Hills, Michigan Member No.: 27,808 Region Association: Upper MidWest |
below is a website to calculate wire size based on estimated current. 8 amps comes out to 14awg in a raceway
http://wiresizecalculator.net/calculators/wiresize.htm |
 |
|
Posts in this topic
captjm Fuel pump relocation and wiring Nov 22 2024, 09:03 PM
dtmehall it was 40 years ago when i did this. i believe you... Nov 22 2024, 09:12 PM JeffBowlsby It’s a 12 ga wire. Nov 22 2024, 09:32 PM dtmehall it was 12 gauge for the fuel injection pump. i wou... Nov 22 2024, 09:38 PM
davep
it was 12 gauge for the fuel injection pump. i wo... Nov 24 2024, 12:24 PM North Coast Jim I ran the wire thru the tunnel wired as above. Bou... Nov 24 2024, 08:22 AM North Coast Jim I ran a two conductor wire thru the tunnel wired a... Nov 24 2024, 08:25 AM SirAndy If you still have the original wiring the fuel pum... Nov 24 2024, 07:26 PM bkrantz
If you still have the original wiring the fuel pu... Nov 24 2024, 08:42 PM dtmehall That's a good idea. It wasn't possible in ... Nov 24 2024, 07:36 PM worn
That's a good idea. It wasn't possible in... Nov 24 2024, 07:43 PM worn
That's a good idea. It wasn't possible i... Nov 24 2024, 07:44 PM |
4 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
1 Members: dtmehall
|
Lo-Fi Version | Time is now: 24th November 2024 - 09:25 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.