 Bowden heater cable grommet |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Peaty |
 Dec 4 2024, 10:25 PM
Post
#1
|
|
Newbie  Group: Members Posts: 4 Joined: 18-March 22 From: CA Member No.: 26,406 Region Association: Southern California  |
Does anyone have a trick to install the grommet that allows the three "Bowden cable" heater controls to pass through the interior bulk head to the heater control box located in the gas tank area?
|
   |
 
|
  |
Replies
| bdstone914 |
Dec 4 2024, 11:14 PM
Post
#2
|
|
bdstone914 Group: Members Posts: 4,735 Joined: 8-November 03 From: Riverside CA Member No.: 1,319 |
QUOTE(Peaty @ Dec 4 2024, 10:25 PM)  Does anyone have a trick to install the grommet that allows the three "Bowden cable" heater controls to pass through the interior bulk head to the heater control box located in the gas tank area? Have not tried it on that particular gromett but lube the groove and edges of the gromett, warm it with a heat gun, wrap several rounds of waxed dental gloss in the gromett grove leaving the loose end on the side that the lip is being pulled thru. insert as much of the lip thru the hole. Tie a loop in the end of the dental floss and pull the lip of the gromett thru. pther technoque is use a smal diameter right angle pic the pull the lip thru the hole. |
|
|
|
Posts in this topic
Peaty Bowden heater cable grommet Dec 4 2024, 10:25 PM
Peaty
Does anyone have a trick to install the grommet ... Dec 5 2024, 11:15 AM
914Sixer Put it in some boiling water to make it pliable. Dec 5 2024, 07:10 AM Peaty
Put it in some boiling water to make it pliable.
... Dec 5 2024, 11:18 AM ClayPerrine Buy a nice, new, soft one from 914Rubber? They go... Dec 5 2024, 07:37 AM Peaty
Buy a nice, new, soft one from 914Rubber? They g... Dec 5 2024, 11:21 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th December 2024 - 07:33 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.