 Installing the shifter springs |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jrrobertson |
 Jan 11 2025, 09:03 PM
Post
#1
|
|
Newbie  Group: Members Posts: 42 Joined: 28-December 16 From: Wolverine Lake , Michigan Member No.: 20,704 Region Association: Upper MidWest 
 |
I can't get the shifter springs installed. I thought there was a thread on this but I could not find it. Could anyone share the procedure with me or tell me where I can locate the instructions?
 |
   |
 
|
  |
Replies
| Shivers |
Jan 11 2025, 09:38 PM
Post
#2
|
|
Senior Member Group: Members Posts: 2,869 Joined: 19-October 20 From: La Quinta, CA Member No.: 24,781 Region Association: Southern California |
I did the punch but I grabbed the other end with vice grips and forced the spring into the other holes location. Then moved the vice grips tilting sideways to start flattening the spring into place as I am putting pressure on the punch to drive it through the spring to the other holes location. It worked really well even with limited room.
 |
|
|
|
Posts in this topic
jrrobertson Installing the shifter springs Jan 11 2025, 09:03 PM
Garland
Here’s the link:
“2012 World post link”
... Jan 11 2025, 09:14 PM jrrobertson Thanks, John. See you Monday. Jan 11 2025, 09:19 PM r_towle A vice is much safer….just sayin Jan 11 2025, 10:16 PM mepstein However you do it, wear eye protection Jan 12 2025, 05:59 AM
Puebloswatcop
However you do it, wear eye protection
Eye prot... Jan 12 2025, 09:56 AM rhodyguy Slip a putty knife into the spring end without the... Jan 12 2025, 10:26 AM mepstein I use a Phillips screwdriver and vise grips. Takes... Jan 12 2025, 10:52 AM Ron914 I need to do this to my car , I bought two new spr... Jan 12 2025, 11:17 AM technicalninja Stiffens the assembly.
A little bit less "sl... Jan 12 2025, 02:03 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 12th January 2025 - 03:57 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.