 Cylinder to Block Gaskets, 2.0 Type IV |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Rhodes71/914 |
 Feb 20 2005, 04:18 PM
Post
#1
|
|
Glacier  Group: Members Posts: 1,374 Joined: 8-August 04 From: End of the Road, Alaska Member No.: 2,482  |
Seems like I read somewhere to leave these out.
Well... |
   |
 
|
  |
Replies
| sean_v8_914 |
Feb 22 2005, 04:20 PM
Post
#2
|
|
Chingon 601 Group: Members Posts: 4,011 Joined: 1-February 05 From: San Diego Member No.: 3,541 |
oh yeah, I should mention that at 60cc (hypothetically)it was a nice 8.5 to 1 but at the actual 50cc measured value it would be over 10 to 1. I think this would have been a disaster on pump gas
|
|
|
|
Posts in this topic
Rhodes71/914 Cylinder to Block Gaskets Feb 20 2005, 04:18 PM
Type 4 http://www.dolphinsci.com/techbull.html Feb 20 2005, 04:25 PM Headrage No head gaskets. I did lap mine to try and get a ... Feb 20 2005, 04:34 PM Rhodes71/914 Sorry I titled the thread wrong, actually meant "s... Feb 20 2005, 05:02 PM Headrage If your talking about the cylinder to case shims, ... Feb 20 2005, 05:14 PM Demick You need to measure your deck height (without shim... Feb 20 2005, 05:44 PM Jake Raby Don't just bolt the engine together without cc... Feb 21 2005, 07:37 AM Joe Ricard Banging your piston against the head is not a good... Feb 21 2005, 09:27 AM Rhodes71/914 OK hypothetically speaking I should not have to mu... Feb 21 2005, 04:52 PM Dave_Darling Well, hypothetically all machine-work is absolutel... Feb 22 2005, 04:04 PM sean_v8_914 I use this calculator here
http://www.btinternet.c... Feb 22 2005, 04:15 PM
|
6 User(s) are reading this topic (6 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 08:03 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.