Tony's Subaru Conversion Thread Options

[TonyAKAVW]

Well, I figured since there has been some pickup in momentum on this project that I would start a thread on my progress. Not to mention its a good way to share whatever ideas I pick up along the way.

The project started in January 2003 when I picked up the silver roller pictured below. Its a '74 and was pretty much stripped. It had a suspension and a few other parts but was missing a lot of major things like and engine, transmission, glass, hoods, gas tank, interior, wheels, etc. etc.

The story of my acquisition of this roller is in this thread:

http://www.914world.com/bbs2/index.php?act=...&f=2&t=7991&hl=

After arriving at home:

http://www.914world.com/bbs2/index.php?act=...&f=2&t=8963&hl=

This project got a bit of a slow start. I had to first part and chop up my first 914 and dispose of it. It was badly rusted and where itwasn't rusted it was bondo'd. This was going to be a replacement body for that car.

Then last summer I picked up the yellow '70 roller that is now my daily driver. Since then I've spent most of my 914 time fixing it up and getting it ready for WCC. Now that its in a pretty much stable state and WCC is over I can concentrate on this car.

The current plan is that it will get a Subaru 2.5L naturally aspirated engine in a conversion very similar to Scott Thacher's. The basic timeline is like this:

1. Fix up the body enough to make it roadworthy.
2. Put together the drivetrain (engine, adapter, transmission)
3. Install drivetrain and remaining parts
4. Install an exhaust system and wire up the engine, make it ready to drive
5. Install enough interior to drive it.
6. Drive it around a bit, fix whatever things don't work right
7. Flare the fenders (GT flares)
8. body and paint
9. Finish the interior
10.Performance mods - cams, etc.

I'm hoping that I get it at least roadworthy within a year, and the rest of the stuff within a year after that. Its possible I could get it done faster but we'll see. This is a big project.

Here's the car as it was when I brought it home:

[scotty914]

here is a cheap and easy way to get engine bay light... get one of the ricer light kits and install it on the firewall with a small switch that is a nc contact that gets released when the engine lid is up. this would cost about 20 bucks or so to do.

as for a bulk head connector, if you do that make sure it is not behind the radiator, for access reasons. also a good source for a connector is an early suby firewall connector they are like 26 pins and the pins are available new

edit: i would still do the radiator mounting now, so you dont have to move it later when you see it is in they way

This post has been edited by scott thacher: May 21 2005, 10:30 PM