transmission question, removing synchro hub from gear |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
transmission question, removing synchro hub from gear |
ws91420 |
Jun 3 2005, 02:25 PM
Post
#1
|
Yes I have one a Lensley 914 Group: Members Posts: 2,063 Joined: 10-September 03 From: Ruther Glen,VA (halfway between sticks and civilization) Member No.: 1,137 Region Association: MidAtlantic Region |
Is there anyway to do this w/o the special tool? Do you need a special tool to install it as well?
|
Cano |
Jun 3 2005, 02:54 PM
Post
#2
|
Member Group: Members Posts: 110 Joined: 29-September 04 From: Goshen, KY Member No.: 2,854 Region Association: None |
IF you are replacing the dogteeth (why else would you remove it from the gear?) you do not need the special tool. I was able to cut/grind my 2nd gear dogteeth almost all the way off without touching the gear. Then it was just a matter of using a chisle (sp?) and hammer to get it the rest of the way off.
To install the new one, I just used a block of wood and a 3 pound hammer to bang it on. JUst make sure it goes on evenly and fully. |
Lo-Fi Version | Time is now: 26th September 2024 - 11:48 AM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |