 TRUNK LID, straightn |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ericg |
 Jun 20 2005, 09:36 PM
Post
#1
|
|
Newbie  Group: Members Posts: 4 Joined: 8-June 05 From: Los Angeles Member No.: 4,233  |
(IMG:http://www.914world.com/bbs2/html/emoticons/screwy.gif) how can the front & rear trunk lids be straightend to sit flat
|
   |
 
|
  |
Replies
| vertigo |
Jun 22 2005, 07:52 AM
Post
#2
|
|
Member Group: Members Posts: 72 Joined: 12-June 05 From: Porterville, Ca Member No.: 4,262 |
For the rear check the pivot points, my driver side weld had come apart and hood would raise about 3/8 inch. JWest engineering carries replacement part for this. (www.jwesteng.com) After I replaced mine the hood still was raised just a bit on driver rear. I adjusted the trunk latch and now it sits correctly.
|
|
|
|
Posts in this topic
ericg TRUNK LID Jun 20 2005, 09:36 PM
xsboost90 mine had a few adjustments. It has the stoppers on... Jun 20 2005, 09:56 PM Natedog I was told once by some old body shop guys that th... Jun 21 2005, 08:49 AM
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th September 2024 - 05:21 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.