Tony's Subaru Conversion Thread Options

[TonyAKAVW]

Well, I figured since there has been some pickup in momentum on this project that I would start a thread on my progress. Not to mention its a good way to share whatever ideas I pick up along the way.

The project started in January 2003 when I picked up the silver roller pictured below. Its a '74 and was pretty much stripped. It had a suspension and a few other parts but was missing a lot of major things like and engine, transmission, glass, hoods, gas tank, interior, wheels, etc. etc.

The story of my acquisition of this roller is in this thread:

http://www.914world.com/bbs2/index.php?act=...&f=2&t=7991&hl=

After arriving at home:

http://www.914world.com/bbs2/index.php?act=...&f=2&t=8963&hl=

This project got a bit of a slow start. I had to first part and chop up my first 914 and dispose of it. It was badly rusted and where itwasn't rusted it was bondo'd. This was going to be a replacement body for that car.

Then last summer I picked up the yellow '70 roller that is now my daily driver. Since then I've spent most of my 914 time fixing it up and getting it ready for WCC. Now that its in a pretty much stable state and WCC is over I can concentrate on this car.

The current plan is that it will get a Subaru 2.5L naturally aspirated engine in a conversion very similar to Scott Thacher's. The basic timeline is like this:

1. Fix up the body enough to make it roadworthy.
2. Put together the drivetrain (engine, adapter, transmission)
3. Install drivetrain and remaining parts
4. Install an exhaust system and wire up the engine, make it ready to drive
5. Install enough interior to drive it.
6. Drive it around a bit, fix whatever things don't work right
7. Flare the fenders (GT flares)
8. body and paint
9. Finish the interior
10.Performance mods - cams, etc.

I'm hoping that I get it at least roadworthy within a year, and the rest of the stuff within a year after that. Its possible I could get it done faster but we'll see. This is a big project.

Here's the car as it was when I brought it home:

[TonyAKAVW]

I didn't know that there were fans that mounted to the radiator itself. That definitely seems like the way to go.

As far as the radiator touching the firewall, I have to see how all this fits in the engine bay. I'm sure there will be some adjusting of the design once I have things roughly in place. This is just a first cut at it, nothing is measured. I may end up pushing the mount back towards the engine slightly to get the clearance if I need it, but I'll see when the time comes.

Andrew: I agree. But I also want this thing to be sturdy enough that when I go over speed bumps it doesn't tear it off. I'd like to be able to go over speed bumps (slowly) and have the thing stay intact, move out of the way, and then move back when the bump is over. After time this will wear down the leading edge of the scoop, but maybe I can put a strip of some really hard metal on there, like tungsten or something!!! or not.


-Tony