 What's up with these exhaust studs?, on my 6.. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| DougC |
 Jul 22 2005, 08:14 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 949 Joined: 6-July 04 From: Dallas, TX Member No.: 2,307  |
I noticed last night that when I mount my headers in place the exhaust studs are too long...well they have a skinny unthreaded area in the middle and the nut would bottom out before touching the header flanges. If all nuts were tight the header would still not fit tightly to the block. Here's a pic..
Doug C Attached image(s) 
|
   |
 
|
  |
Replies
| DougC |
Jul 22 2005, 08:46 AM
Post
#2
|
|
Senior Member Group: Members Posts: 949 Joined: 6-July 04 From: Dallas, TX Member No.: 2,307 |
Yes, I will be replacing ...but again, with what???
If I get the same ones (new) they will still be too long for the bursch flanges. Maybe theres a fully threaded stud I should use? BTW, it's a 2.7 Doug C |
|
|
|
Posts in this topic
DougC What's up with these exhaust studs? Jul 22 2005, 08:14 AM
DougC another... Jul 22 2005, 08:14 AM TimT You get to install new exhaust studs!! the... Jul 22 2005, 08:18 AM DougC Tim, it really looks like they were machined this ... Jul 22 2005, 08:26 AM ! The 3.0s had a thick/thin flange difference.....bu... Jul 22 2005, 08:33 AM DonTraver Easy to figure out. Measure the depth of the stud... Jul 22 2005, 08:57 AM Porsche Rescue Use the ones you have to come up with a length. Th... Jul 22 2005, 08:57 AM ClayPerrine Doug,
The thermal reactors used on the 2.7 requir... Jul 22 2005, 11:52 AM ClayPerrine Oh.. and the easiest way to remove the studs is to... Jul 22 2005, 11:52 AM Cap'n Krusty Yet another case of wild speculation coupled with ... Jul 22 2005, 12:58 PM
ArtechnikA the PET wouldn't help you, i'm afraid beca... Jul 22 2005, 01:47 PM |
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 6th January 2025 - 08:34 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.