more CV questions ... Options

[SirAndy]

ok, i got the 944 CV's off the shaft ...

i wanted to know if the wear was too bad so i took them apart.
looking good! almost no wear (came off a 944 turbo) ...

i cleaned them up thoroughly as i was told not to mix different kinds of CV grease and now the question is:

how do i pack them with new grease?
grease the parts first, then try to assemble or assemble dry and then pack the whole thing?
(IMG:http://www.914world.com/bbs2/html/emoticons/idea.gif) Andy

[flesburg]

Andy:

WOW!, Andy, That is the slickest picture story of a how to on cv joint assembly I have ever seen. Flat on a bench!!, so the balls do not fall out in your lap. I'm going to print out your set of pictures, and then I'm going to try this over the weekend with an old cv joint. I bet even I can do this.

I have always tried it setting down in a chair and at a table, but with the cv joint in my hands and a little clean grease to make the balls sticky, but then there is a solution for every puzzel, we just go through life without the solutions. Too soon old and too late smart as they say.

Is there a similar "solution" to the rubics cube?

Thanks for sharing the solution, and with such a neat set of pictures.