 Will this kill rear wheel bearing?, Or, Where's Mr. Cotter |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| mskala |
 Jul 24 2005, 07:49 PM
Post
#1
|
|
R  Group: Members Posts: 1,927 Joined: 2-January 03 From: Massachusetts Member No.: 79 Region Association: None 
 |
Car was feeling funny after AX, like when you change lanes
it took more input to get it to straighten out again. Felt left rear wheel, movement similar to when front bearings are loose. Felt castle nut pin left. Jacked up, wheel moves 1/4" in vertical plane. Oops. Maybe I used too small a cotter pin, but crap the thing was just better than hand tight by this point. Anyhoo, I air-wrenched it on good again, put in the biggest cotter pin that could possibly fit, and feels good (in garage). Question is, would driving like that have already ruined the wheel bearing? Thanks, |
   |
 
|
Posts in this topic
brp914 I had that happen. The rotor dragged against the ... Jul 24 2005, 08:21 PM Joe Ricard Does it wiggle after you tightened it? Yes then t... Jul 24 2005, 08:57 PM
mskala So far looks good. I'll probably put a new on... Jul 25 2005, 02:58 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 21st December 2024 - 07:52 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.