 Fan not centered, What has happened?? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| IanStott |
 Nov 18 2005, 04:46 AM
Post
#1
|
|
Member  Group: Members Posts: 226 Joined: 13-June 04 From: Moncton,New Brunswick,Canada Member No.: 2,199  |
OK, I have messed up somehow, I took all the engine tin off, the fan and large fan shroud etc., had stuff powder coated and cleaned. Started putting things back on last night and the fan is not centered in it's hole, it is touching on the alternator side. What has happened?
Ian Stott Moncton |
   |
 
|
  |
Replies
| Jeffs9146 |
Nov 18 2005, 04:23 PM
Post
#2
|
|
Ski Bum Group: Members Posts: 4,062 Joined: 10-January 03 From: Discovery Bay, Ca Member No.: 128 |
I had this problem when I rebuilt my Alt. It turned out that the shop that rebuilt it didn't tighten the Screws that go all the way to the rear nuts on the Alt. enough so when I put the belt on it pulled the fan into the housing. Once the screws and rear bolts were tightened up the problem went away!
Jeff |
|
|
|
Posts in this topic
IanStott Fan not centered Nov 18 2005, 04:46 AM
URY914 ... Nov 18 2005, 08:12 AM IanStott yes I mean the large aluminium housing, I will try... Nov 18 2005, 09:23 AM type11969 For future reference, I wouldn't use that bolt... Nov 18 2005, 09:31 AM URY914 I use that bolt to turn my engine over but I do re... Nov 18 2005, 09:58 AM IanStott I may have overtightened that bolt! Can I just... Nov 18 2005, 10:04 AM URY914 ... Nov 18 2005, 10:08 AM type11969 I thought that if you tighten that bolt beyond spe... Nov 18 2005, 10:20 AM IanStott I'm starting to get worried as my clutch and f... Nov 18 2005, 12:14 PM bondo Is the distributor in? If the drive gear moves, it... Nov 18 2005, 12:24 PM type11969 Check to make sure that the hub or any bolts going... Nov 18 2005, 12:35 PM IanStott I'm going to take it all off and start again b... Nov 18 2005, 12:52 PM
IanStott Okay here is what happened! The powder coating... Nov 20 2005, 08:25 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th June 2024 - 09:33 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.