Adding dog-ear reinforcement, Really going into details. |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Adding dog-ear reinforcement, Really going into details. |
michel richard |
Mar 12 2006, 04:17 PM
Post
#1
|
Senior Member Group: Members Posts: 1,291 Joined: 22-July 03 From: Longueuil, Québec Member No.: 936 |
On my /6 project, I have decided not to add the tub reinforcements on the inside rear wheel well, for a variety of reasons. I did decide that I wanted the dog-ear reinforcement, also for a variety of reasons.
I am building the whole thing from scratch and I will post a detailed picture sequence in the hope that some will find it interesting. I first bought some cold-rolled flat stock, 1/4 inch by 1.5 inch. I will say that I did not try to calculate if this resulted in a tang of the right strength, but it's what I used. There's 8 tangs required, 6 the same and 2 a little longer. To make the tangs, I began by drilling a 3/8 inch hole: Attached image(s) |
michel richard |
Mar 12 2006, 04:32 PM
Post
#2
|
Senior Member Group: Members Posts: 1,291 Joined: 22-July 03 From: Longueuil, Québec Member No.: 936 |
This part gets welded to the main bulkhead, as shown below.
What remains is to (1) put together the tangs that will be welded to the dog-ear itself, (2) and to make the rod that will go between the bulkhead and the dog-ear and (3) do the welding to the tub. Picture below from Armando Serrano's site: Attached image(s) |