 pops out of 2 nd gear after rebuild, need experienced advice. |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| vincesix |
 Jun 15 2006, 05:45 PM
Post
#1
|
|
Newbie  Group: Members Posts: 38 Joined: 20-December 04 From: Riverside,CA Member No.: 3,313  |
with all new syncros, mainshaft bearing, 5th gear and everything else checked as good including the shift rod and bushings. doubled checked the fork and all settings and the SOB will not stay in 2 nd under power. WTF.
|
   |
 
|
  |
Replies
| Brad Roberts |
Jun 16 2006, 12:15 PM
Post
#2
|
|
914 Freak! Group: Members Posts: 19,148 Joined: 23-December 02 Member No.: 8 Region Association: None |
I'm going to be in Riverside tomorrow after the fun run and before the AutoX. I dont mind stopping by to take a look at it.
Pull the back cover off and pull the entire assembly out of the case. Leave the tranny/starter/axles/clutch cable all hooked up. You can drop the back of the engine/tranny down far enough to get the top M8 nut off the tranny cover and slide everything out. Have it on a bench for me. Your call. B |
|
|
|
Posts in this topic
vincesix pops out of 2 nd gear after rebuild Jun 15 2006, 05:45 PM
Brad Roberts Did you replace the 2-3 slider and brake band for ... Jun 15 2006, 05:47 PM vincesix yes they are new and we have manually put the car ... Jun 16 2006, 09:44 AM Brad Roberts You have the shift fork out of alignment. It is no... Jun 16 2006, 09:51 AM vincesix 1st, 3rd 4th and 5th are fine. I will work on a pi... Jun 16 2006, 11:53 AM Brad Roberts Which is why I didnt say anything about your linka... Jun 16 2006, 12:11 PM Demick Can also be that the shifter detent balls/spacers/... Jun 16 2006, 12:51 PM
Brad Roberts I thought a lot about the ball/spacers/detent.
If... Jun 16 2006, 12:56 PM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th June 2024 - 03:49 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.