 Can the trunk lids be adjusted at the latches? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Mid_Engine_914 |
 Nov 18 2006, 02:41 PM
Post
#1
|
|
Member  Group: Members Posts: 195 Joined: 22-September 06 From: Left Coast Member No.: 6,888  |
Both my front and rear trunk lids don't fit flush with the fenders (they sit about a 1/4 in. high) so I was wondering how can I adjust them so they fit as good as on Trevorg7's car?
(IMG:http://www.914world.com/bbs2/uploads/post-3241-1163556748.jpg) (IMG:http://www.914world.com/bbs2/uploads/post-3241-1163556839.jpg) |
   |
 
|
  |
Replies
| Mid_Engine_914 |
Nov 18 2006, 08:04 PM
Post
#2
|
|
Member Group: Members Posts: 195 Joined: 22-September 06 From: Left Coast Member No.: 6,888 |
Thanks for the advice. I adjusted the front trunk latch downward as far as it would go and now the front trunk lid fit’s a bit better. I think the problem with the rear trunk lid may have to do with the old trunk seals because after I removed them the lid fit much better.
|
|
|
|
Posts in this topic
Mid_Engine_914 Can the trunk lids be adjusted at the latches? Nov 18 2006, 02:41 PM
Chogokin I have the same problem, I was thinking about putt... Nov 18 2006, 02:44 PM abearauto if you can supply any photos here then i can walk ... Nov 18 2006, 05:55 PM 914Sixer Do not forget to adjust the rubber stopper in each... Nov 18 2006, 06:49 PM Jeff Bowlsby The rear trunk male part on the lid has a big nut ... Nov 18 2006, 06:55 PM
abearauto if the old trunk seals are oem , putting new ones ... Nov 18 2006, 09:07 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st October 2024 - 07:29 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.