Powdercoated rear hubs/flanges?, surface not flat due to coating... |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
Powdercoated rear hubs/flanges?, surface not flat due to coating... |
Mueller |
Nov 26 2006, 11:45 PM
Post
#1
|
914 Freak! Group: Members Posts: 17,150 Joined: 4-January 03 From: Antioch, CA Member No.: 87 Region Association: None |
I am doing some work on Felix's (neo914-6) rear trailing arms, they are freshly powdercoated and look nice...however, my concern is the powdercoating on the rear hubs.
In the picture you can see a lip due to the coating....when measured using a flat edge, I can get a .0025" feeler gauge under the flat edge in varied areas of the hub. |
So.Cal.914 |
Nov 27 2006, 02:11 AM
Post
#2
|
"...And it has a front trunk too." Group: Members Posts: 6,588 Joined: 15-February 04 From: Low Desert, CA./ Hills of N.J. Member No.: 1,658 Region Association: None |
If it is thicker on one side than the other the wheel will not ride true. Not so
important at slow speeds but..... |
Lo-Fi Version | Time is now: 21st September 2024 - 07:09 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |