 Crap, ordered the wrong ball joint, Need some advice.... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jr91472 |
  Dec 27 2006, 03:56 PM
Post
#1
|
|
"I'm pacing myself sergeant..."  Group: Members Posts: 1,205 Joined: 2-August 04 From: McKinney, TX Member No.: 2,437  |
I need to replace the ball joints that go on the end of the tie rods, but instead I ordered the ball joint that mounts the suspension to the A-arm. (IMG:style_emoticons/default/dry.gif)
I am trying to tighten up my steering as it feels a bit wobbly and I can see "looseness" at the tie rod ends. But the question now is: should I go ahead and do the other ball joints since I have them. I don't "think" the A-arm ball joints are bad, but honestly I am not sure how to tell if they are or not. Is this a big job? Sounds like I need a special tool. What other hardware is required? help! |
   |
 
|
  |
Replies
| Joe Bob |
Dec 27 2006, 04:45 PM
Post
#2
|
|
Retired admin, banned a few times Group: Members Posts: 17,427 Joined: 24-December 02 From: Boulder CO Member No.: 5 Region Association: None |
if the ones on your ride are 30 years old and you have the right parts do it right and put em on....
|
|
|
|
Posts in this topic
jr91472 Crap, ordered the wrong ball joint Dec 27 2006, 03:56 PM
Cap'n Krusty What you want are "tie rod ends". They... Dec 27 2006, 04:03 PM John
I need to replace the ball joints that go on the ... Dec 27 2006, 04:06 PM jr91472 Well I DO have the correct early style ball joint,... Dec 27 2006, 05:43 PM Aaron Cox i have the special socket....
i can loan it to yo... Dec 27 2006, 05:49 PM
jr91472
i have the special socket....
i can loan it to y... Dec 27 2006, 06:14 PM dakotaewing JR -
If you are going to replace the ball joints, ... Dec 27 2006, 06:09 PM jr91472
JR -
If you are going to replace the ball joints,... Dec 27 2006, 06:17 PM ClayPerrine No, I don't have the special socket for the ba... Dec 28 2006, 09:42 AM jr91472
No, I don't have the special socket for the b... Dec 28 2006, 10:19 AM |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 11:25 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.