 oil pressure light, on dash flickering |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jimkelly |
 Mar 11 2007, 07:42 AM
Post
#1
|
|
Delaware USA  Group: Members Posts: 4,969 Joined: 5-August 04 From: Delaware, USA Member No.: 2,460 Region Association: MidAtlantic Region  |
i noticed that a wire going to the coil sends a signal to the light - is this correct or could this be my problem causing the flickering?? if i disconnect this wire the light goes out. jim
|
   |
 
|
  |
Replies
| So.Cal.914 |
Mar 11 2007, 12:31 PM
Post
#2
|
|
"...And it has a front trunk too." Group: Members Posts: 6,588 Joined: 15-February 04 From: Low Desert, CA./ Hills of N.J. Member No.: 1,658 Region Association: None |
It should be a green and red, I think, wire (old wire= red may look brown) it
should connect to the oil preasure switch. You will find it behind the dizzy (torwards rear of car) thru a hole in the sheet metal, only a few inches from your dizzy IIRC. |
|
|
|
Posts in this topic
jimkelly oil pressure light Mar 11 2007, 07:42 AM
ClayPerrine
i noticed that a wire going to the coil sends a s... Mar 11 2007, 07:46 AM vsg914 Oil pressure light does not attach to the coil. It... Mar 11 2007, 07:46 AM jimkelly i do not have my haynes with me and still have lot... Mar 11 2007, 12:10 PM
jimkelly ok - got it -- but -- sensor must have been previo... Mar 11 2007, 01:05 PM So.Cal.914
ok - got it -- but -- sensor must have been previ... Mar 11 2007, 01:09 PM jimkelly here it is... Mar 11 2007, 03:13 PM Aaron Cox looks like a drill and EZ out operation?
i believ... Mar 11 2007, 04:07 PM So.Cal.914 :agree:
looks like a drill and EZ out operation?
... Mar 11 2007, 04:10 PM jimkelly thanks guys : ) Mar 11 2007, 04:11 PM Aaron Cox what did you coil's oil pressure look like BTW... Mar 11 2007, 04:12 PM So.Cal.914 About 10,000 volts PSI. Mar 11 2007, 04:15 PM Brando About 10,000 volts PSI.
:lol2: The higher your RPM... Mar 11 2007, 04:36 PM SLITS
About 10,000 volts PSI.
:lol2: The higher your RP... Mar 11 2007, 09:31 PM Aaron Cox :chairfall:
back to studying...... Mar 11 2007, 04:16 PM jimkelly guess i am the first with an oil cooled coil : ) Mar 11 2007, 04:20 PM Aaron Cox (actually, most coils do have oil in them .... sha... Mar 11 2007, 04:24 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th June 2024 - 05:59 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.