 CV differences ? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| scotty b |
 Nov 21 2007, 08:31 PM
Post
#1
|
|
rust free you say ?  Group: Members Posts: 16,375 Joined: 7-January 05 From: richmond, Va. Member No.: 3,419 Region Association: None  |
Last weekend I FINALLY got around to doing something on my dads car again. I put his axles back together ! Upon assembly I noticed there were 2 different cages and two different sized bearings. Obviously the O.D. of the cages was the same but the spots where the bearings "snap" in was different. To make things even more interesting I also had some 944 axles (CV's) apart. Upon examination of them I find the larger 914 bearings are the same as the 944 bearings ! What gives with the smaller diamater bearings ? are the bearings year specific or maybe inside/outside specific ???????
|
   |
 
|
  |
Replies
| scotty b |
Nov 24 2007, 03:38 PM
Post
#2
|
|
rust free you say ? Group: Members Posts: 16,375 Joined: 7-January 05 From: richmond, Va. Member No.: 3,419 Region Association: None |
For comparison.
This is the 914 cage that uses the larger bearing beside a 944 cage that uses the same bearing Attached image(s) 
|
|
|
|
Posts in this topic
scotty b CV differences ? Nov 21 2007, 08:31 PM
sww914 I don't know if all of the 914 CV's were t... Nov 21 2007, 08:39 PM alpha434 The cage is WAY beefier, too, right? Nov 21 2007, 08:44 PM
scotty b
The cage is WAY beefier, too, right?
I'll c... Nov 22 2007, 08:09 PM alpha434 I've been screwing around with the CVs on my c... Nov 23 2007, 01:12 AM scotty b
I've been screwing around with the CVs on my ... Nov 24 2007, 03:41 PM scotty b Meaurements and pics !! Nov 24 2007, 03:37 PM alpha434 Nope. The parts are right. I put it under a cmm, a... Nov 25 2007, 08:03 AM scotty b
Nope. The parts are right. I put it under a cmm, ... Nov 25 2007, 04:00 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 31st October 2024 - 07:29 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.