Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> Need measurement between trailing arms..., to determine correct axle length w/Boxster trans
neo914-6
post Dec 2 2007, 09:33 AM
Post #1


neo life
*****

Group: Members
Posts: 5,086
Joined: 16-January 03
From: Willow Glen (San Jose)
Member No.: 159



I'm not sure if this would be a consistent measurement from car to car. My arms have been rebuilt and I can't get them to an alignment shop. I need to make sure my axles have the correct lengths. Because of the Boxster design, they are unequal.

1. I need measurement between the inner faces of the arms.

2. What is the longitudinal tolerance of Constant Velocity joints? This will determine if I need to have the axle(s) modified.


User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
toon1
post Dec 2 2007, 04:03 PM
Post #2


Senior Member
***

Group: Members
Posts: 1,849
Joined: 29-October 05
From: tracy,ca
Member No.: 5,022



I came up with 38 11/16". front edge of the the large hole.

That large hole has a lip that sticks inward twards the center of the car.

I made the measurement from edge to edge of the lip.

Keith
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 31st October 2024 - 08:21 PM