Home  |  Forums  |  914 Info  |  Blogs
 
914World.com - The fastest growing online 914 community!
 
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG. This site is not affiliated with Porsche in any way.
Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners.
 

Welcome Guest ( Log In | Register )

> OT: Roof framing, alteration
thomasotten
post Dec 10 2007, 02:06 PM
Post #1


Senior Member
***

Group: Members
Posts: 1,556
Joined: 16-November 03
From: San Antonio, Texas
Member No.: 1,349



I have an existing roof on my house that is pitched and creates a cathedral type ceiling underneath. I am considering increasing the pitch of this roof, for ascthetic reasons mostly, but also to add insulation to the roof, which I don't thick is adequetly insulated. There is no attic space right now, so I cant' be sure of the insulation, although it gets hot in summer time. I want the final roof to be 12/12, and to do this, I would need to raise the ridge by about 2'. From the ridge, I would then run rafters down to the bottom of the roof fascia. Instead of raising each rafter up and causing a mess, I am considering building a structure over the exsiting roof, and then sheathing over. That way I don't disturb the ceiling. I was thinking of also doing this in phases, keeping the existing shingles on as a I go. What do you think?
User is offlineProfile CardPM
Go to the top of the page
+Quote Post
 
Reply to this topicStart new topic
Replies
rhodyguy
post Dec 21 2007, 11:46 AM
Post #2


Chimp Sanctuary NW. Check it out.
***************

Group: Members
Posts: 22,193
Joined: 2-March 03
From: Orion's Bell. The BELL!
Member No.: 378
Region Association: Galt's Gulch



if you go the the insulated panel route, ensure you use a closed cell product.

personal liability is a factor to consider when assembling a crew and acting as a 'private contractor'. someone takes a header off the roof, it could cost you dearly. even so much as a "i hurt my back" could become a nightmare. get bids from licenced and bonded contractors. ask for past customers and get feedback. a good contractor should be more than happy to provide this info. ask the usual ?. was the work completed in a timely fashion? was the yard a pig sty when the job was finished?

when we did our roof (2 layers of comp), the contractor showed up with a scissor lift bed truck for hauling away the waste. a tear off crew of 8 or so and it was stripped and papered in 1 day. next day, 2 roofers and the shingling was done in 2 days. after all was said and done there was not so much as a piece trash in the flower beds.

k
User is offlineProfile CardPM
Go to the top of the page
+Quote Post

Posts in this topic
thomasotten   OT: Roof framing, alteration   Dec 10 2007, 02:06 PM
jasons   So, you want to leave your existing roof intact an...   Dec 10 2007, 02:19 PM
Jeff Bowlsby   A couple of things to consider: that amount of wo...   Dec 10 2007, 02:24 PM
jd74914   Don't do it; do it once and do it right. While...   Dec 10 2007, 03:55 PM
thomasotten   Well, I talked about it with a contractor friend. ...   Dec 11 2007, 08:25 AM
flippa   I'm sure that this may be doable and has been ...   Dec 11 2007, 08:56 AM
rick 918-S   Better check local buillding codes. Around here th...   Dec 11 2007, 10:13 AM
brer   So its an open beam ceiling right? Very nice to ...   Dec 11 2007, 10:28 AM
rhodyguy   existing roof (3 tab, etc) tear off is an equal we...   Dec 11 2007, 12:20 PM
thomasotten   What is the typical procedure? I would have to su...   Dec 12 2007, 07:51 AM
jd74914   Typically you need to get plans and then submit fo...   Dec 12 2007, 09:51 AM
rick 918-S   Typically you need to get plans and then submit f...   Dec 12 2007, 10:59 PM
flippa   Thomas Do a search on your City regulations on li...   Dec 13 2007, 08:59 AM
r_towle   be careful to investigate the fire code. In MA, wh...   Dec 20 2007, 06:09 PM
banger   I had a similar situation. I have a cathedral cei...   Dec 20 2007, 06:37 PM
rhodyguy   if you go the the insulated panel route, ensure yo...   Dec 21 2007, 11:46 AM
thomasotten   This is my plan, by the way, notice that also, wit...   Dec 23 2007, 04:28 AM
Joe Ricard   This is not really off topic. This reflects what w...   Dec 23 2007, 06:55 AM
thomasotten   Well, it's mostly for asthetic reasons that I ...   Dec 23 2007, 10:33 AM
flippa   Are those 2x4’s that you are proposing for the n...   Dec 23 2007, 04:42 PM
banger   With the radiant barrier, it would be easier to bu...   Dec 23 2007, 04:54 PM


Reply to this topicStart new topic
6 User(s) are reading this topic (6 Guests and 0 Anonymous Users)
0 Members:

 



- Lo-Fi Version Time is now: 27th December 2024 - 06:52 AM