 transmission front main seal, Is there a specific depth |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| toon1 |
 Jan 11 2008, 10:59 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,849 Joined: 29-October 05 From: tracy,ca Member No.: 5,022  |
Is there a specific depth the front main seal of the transmission be installed to?
|
   |
 
|
  |
Replies
| davep |
Jan 11 2008, 11:30 AM
Post
#2
|
|
914 Historian Group: Benefactors Posts: 5,213 Joined: 13-October 03 From: Burford, ON, N0E 1A0 Member No.: 1,244 Region Association: Canada  |
Why would you push it in past the face? I cannot think of any application where the seal is anything other than flush with the face.
|
|
|
|
Posts in this topic
toon1 transmission front main seal Jan 11 2008, 10:59 AM
Cap'n Krusty Knock it in flush. The release bearing guide tube... Jan 11 2008, 11:07 AM toon1 so it should be flush with the top of the flange t... Jan 11 2008, 11:19 AM toon1 There are TWO different faces you could refer to i... Jan 11 2008, 11:44 AM Dr Evil Push it in so that it lies below the plain of the ... Jan 11 2008, 01:26 PM toon1
Push it in so that it lies below the plain of the... Jan 11 2008, 01:43 PM
davep Keith, I think you should be okay. I normally go b... Jan 11 2008, 02:04 PM |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 25th November 2024 - 10:32 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.