 Problem during needle bearing install..., ovalled pivot tube; wtf do I do now?!? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| ss6 |
 Mar 20 2004, 03:28 PM
Post
#1
|
|
fun city...  Group: Members Posts: 261 Joined: 2-February 03 From: Western Connecticut Member No.: 221  |
Got a set of Mueller's nifty suspension bearings, pressed the bearing tube into the trailing arm (BF threaded rod and a LOT of elbow grease), proceeded to test fit the bearings. Fits fine on the outboard end, but the inboard end won't accept the bearing.
Measured the tube ID, and found a slight oval, ie 1.318 - 1.338. The bearing OD that has to fit in there is 1.330. So will the bearing tolerate this or am I going to have to go find a machine shop??? |
   |
 
|
Posts in this topic
ss6 Problem during needle bearing install... Mar 20 2004, 03:28 PM
Doug Leggins The oval condition seems to be common. I talked to... Mar 20 2004, 04:21 PM Racer Chris That's why I ream the trailing arms before ins... Mar 20 2004, 06:20 PM fiid One of my tubes was mushroomed from beating it in ... Mar 20 2004, 08:49 PM
J P Stein I'm with Chris.....tho I haven't got a rea... Mar 20 2004, 10:08 PM  |
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 28th November 2024 - 08:44 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.