 Weber 40idf Venturi Boring |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| tornik550 |
 May 2 2010, 07:26 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,248 Joined: 29-January 07 From: Ohio Member No.: 7,486 Region Association: None  |
I have a few sets of venturis for my Dual Weber 40 idfs. All of the vents are the same size. I was planning on boring a set of the 32mm vents to 34mm and a set to 36mm (long story why I am doing this).
My question. Is there anything special that I must do other than bore out the opening to the desired size. Do I need to shape anything or do I just simply bore it out. I planned on doing this on a metal lathe. Obviously it would be much easier to just bore it out. If I have to shape the vents, I will just send them off. Thanks |
   |
 
|
Posts in this topic
tornik550 Weber 40idf Venturi Boring May 2 2010, 07:26 PM
904svo
I have a few sets of venturis for my Dual Weber 4... May 2 2010, 07:33 PM
tornik550 Thank you!!! May 2 2010, 08:09 PM gopack I dont have the answer, but I would guess there is... May 2 2010, 08:38 PM tornik550
I dont have the answer, but I would guess there i... May 2 2010, 08:47 PM Racer Chris I sell 36mm venturis but most people just alter th... May 2 2010, 08:48 PM gopack added a little ( very little ) research to my pre... May 2 2010, 08:50 PM wayneosan I'm just a new guy that is really into Weber... May 2 2010, 10:54 PM tornik550
I'm just a new guy that is really into Weber... May 3 2010, 08:37 AM wayneosan progress?? May 10 2010, 06:04 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th January 2025 - 08:37 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.