 Reinstalling inner CV, With engine and tranny in car |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| jeffdon |
 Feb 20 2011, 02:38 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,094 Joined: 24-October 06 From: oakland, ca Member No.: 7,087 Region Association: None  |
Trying to put my inboard CV joint back on the splined end of the axle with everything in the car. I got it about 1/8" onto the spline, and now it seems to be calling for some tapping with a hammer to get it on the rest of the way. However, i have no clearance to swing a hammer, and the tranny is in the way of a long punch.
Anyone got a trick for doing this? |
   |
 
|
Posts in this topic
jeffdon Reinstalling inner CV Feb 20 2011, 02:38 PM
Andyrew Take it out and inspect the splines. Inspect the h... Feb 20 2011, 03:11 PM
jeffdon
Take it out and inspect the splines. Inspect the ... Feb 20 2011, 03:55 PM Andyrew Put the nut on and tighten it on. Feb 20 2011, 06:30 PM type47
Put the nut on and tighten it on.
nut?? ... ... Feb 21 2011, 01:26 PM r_towle did this once in the car, it sucked getting that c... Feb 21 2011, 01:41 PM Andyrew I was thinking outer hub.. my bad Feb 21 2011, 07:12 PM  |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 05:52 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.