 Oil Pressure Guage, Doesn't work |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 2-OH! |
 Aug 12 2004, 01:23 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 552 Joined: 17-October 03 From: Santa Clarita, Kalifornication Member No.: 1,253  |
1975-2.0 FI Stock motor
I purchased a new VDO 0-80 PSI gauge and dual sender from a vendor we all use and like... The gauge does not read...The idiot light does go out on the dash once the motor reaches RPM's and I slaved in a direct pressure gauge to make sure I had pressure...plenty of pressure... A test light from the battery to each (dual sender) post on the sender...test light goes out once the motor reaches RPM's... The post on the sender that leads to the gauge... should it produce voltage, if so how much ??? Milivolts or can a standard voltmeter pick it up... Single wire from sender to gauge rings out good with ohm meter and bell ringer... Which do I send back for warranty, the gauge or the sender ??? Probably both ... Any ideas I haven't tried... 2-OH! |
   |
 
|
Posts in this topic
2-OH! Oil Pressure Guage Aug 12 2004, 01:23 PM
lapuwali The sender doesn't produce a voltage, but vari... Aug 12 2004, 02:54 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 2nd January 2025 - 09:13 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.