 accelerator & clutch cable guide tubing |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| shuie |
 Jun 18 2012, 08:09 AM
Post
#1
|
|
Member  Group: Members Posts: 352 Joined: 17-May 04 From: baton rouge, la Member No.: 2,075  |
I thought I should ask before I button up my floors...
I have built new clutch cable and accelerator tubes in my center tunnel. I ran the tubes maybe 4-6" further towards the front of the car than the originals. It seemed like it might be easier to feed the cables that way. Is this okay, or should I cut them back to the normal length? Also, about how far should they poke through the rear firewall? Do they need to point straight to the rear of the car, or are they supposed to be angled? My original firewall was really mangled around the clutch and accelerator tube area, so I don't have a good reference for how the factory did it. TIA |
   |
 
|
Posts in this topic
shuie accelerator & clutch cable guide tubing Jun 18 2012, 08:09 AM
Bartlett 914
I thought I should ask before I button up my floo... Jun 18 2012, 09:47 AM Al Meredith Be carefull , it is easy to twist the gas cable an... Jun 18 2012, 10:08 AM shuie Thanks, I have test fit the clutch cable and accel... Jun 18 2012, 11:40 AM
SirAndy Here's the front of the tubing.
Instead of spo... Jun 18 2012, 12:52 PM seanery
:popcorn:
You eat a lot of popcorn!! ... Jun 18 2012, 06:58 PM pilothyer
This is a picture of an... Jun 18 2012, 12:36 PM toolguy I would make the clutch tube as short as possible.... Jun 18 2012, 07:27 PM shuie SirAndy, I made clamps for the clutch tube and acc... Jun 18 2012, 08:43 PM partwerks I got some plastic tubing and cut some short piece... Jun 18 2012, 10:54 PM Cap'n Krusty If you extend the tube farther outside the firewal... Jun 18 2012, 11:55 PM shuie I cut the tubes at the rear firewall back and test... Jun 22 2012, 08:24 PM Eric_Shea The tubes in the back section still look a tad lon... Jun 22 2012, 10:04 PM  |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd December 2024 - 05:23 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.