 Why is my brake/hazard light still flashing?, Tested everything I can think of so far |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Matty900 |
 Oct 7 2017, 08:52 AM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,284 Joined: 21-February 15 From: Oregon Member No.: 18,454 Region Association: Pacific Northwest  |
My multi gauge in my 72 will not stop flashing (IMG:style_emoticons/default/chair.gif)
First thought was that I needed to reset the master cylinder after the breaks were done. I did that - Still flashing I checked the switch on the emergency brake. I had connected one of the wires for the back pad light to it (IMG:style_emoticons/default/headbang.gif) Fixed that - Still flashing I was blowing a fuse for the drivers side signals. After reading posts I thought this could be indicating I had an issue with lights. I tracked down the ground, fixed the problem - Still flashing I had replaced almost all of the lights in the dash with LEDs. So after reading posts about how the flasher relay works, I swapped these 2 lights and the turn signal lights in the tac back to regular bulbs - Still flashing Any ideas? |
   |
 
|
Posts in this topic
Matty900 Why is my brake/hazard light still flashing? Oct 7 2017, 08:52 AM
Spoke Below is the circuit for the turnsignal/brake warn... Oct 7 2017, 12:09 PM
914_teener
Below is the circuit for the turnsignal/brake war... Oct 7 2017, 04:26 PM arne My car’s 2 wire master cylinder switch was fault... Oct 7 2017, 07:25 PM  |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 06:47 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.