 sandblasting rear brake calipers, what do I watch out for? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| 914 RZ-1 |
 Mar 11 2022, 07:10 PM
Post
#1
|
|
Porsche Padawan  Group: Members Posts: 684 Joined: 17-December 14 From: Santa Clarita, CA Member No.: 18,230 Region Association: Southern California  |
I am rebuilding my rear brakes. I've taken everything apart, cleaned them with Simple Green and am currently soaking the parts in Evaporust. However, I might need to sandblast them.
1. Anything I should know before I proceed? 2. What to plug/tape up? I'm assuming all holes and machined surfaces? 3. What about the area in the caliper where the piston goes? 4. What blasting media should I use? I have some dull aluminum oxide I've used several times. I've looked on the 'Net and found a few tidbits, but nothing specific to 914 brake calipers, so I thought I'd post here and see if anyone had any experience, tips and advice. Thanks! |
   |
 
|
Posts in this topic
914 RZ-1 sandblasting rear brake calipers Mar 11 2022, 07:10 PM
Shivers Some info here
https://www.pmbperformance.com/bra... Mar 11 2022, 10:30 PM 914Sixer Use glass beads not sand. Mar 12 2022, 07:17 AM
914 RZ-1
Use glass beads not sand.
Thanks! Will do... Mar 12 2022, 12:02 PM 914 RZ-1 Here's a photo of the cleaned parts. I've ... Mar 12 2022, 12:12 PM 914Sixer I always cleaned the complete. I used duct tape t... Mar 12 2022, 01:12 PM mepstein Are you getting them replated? Getting the piston ... Mar 12 2022, 01:33 PM Shivers Don't forget to plug the bleeder ports. Mar 12 2022, 02:21 PM Sycolyst I glass beaded mine covering all the internal open... Mar 12 2022, 07:42 PM PatMc
I glass beaded mine covering all the internal ope... Mar 13 2022, 12:41 PM 914 RZ-1 Yes, I will be re-plating them. Can anyone recomme... Mar 13 2022, 07:40 PM PatMc
Yes, I will be re-plating them. Can anyone recomm... Mar 13 2022, 08:54 PM Shivers Three I found on google
Van Nuys Plating Inc
3.... Mar 13 2022, 07:50 PM 914 RZ-1
Three I found on google
Van Nuys Plating Inc
3.... Mar 14 2022, 08:23 PM  |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th January 2025 - 11:43 PM |
Invision Power Board
v9.1.4 © 2025 IPS, Inc.