 At TDC #1 but... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| Literati914 |
 Jul 26 2024, 06:57 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 1,651 Joined: 16-November 06 From: Dallas, TX Member No.: 7,222 Region Association: Southwest Region  |
On a freshly built but never installed, never ran.. oil never added and sitting for years 1.7L engine: I've verified TDC @ #1 but the rotor tip is showing 180 deg. out.
Is that just a matter of loosening a bolt and rotating it to face towards the driver's seat (apprx).. or is it gonna be more of a 'pull the distributor and re-clock the gear down in the bore' ? . |
   |
 
|
Posts in this topic
Literati914 At TDC #1 but... Jul 26 2024, 06:57 PM
Artfrombama
On a freshly built but never installed, never ran... Jul 26 2024, 07:03 PM Literati914
The #1 piston is at TDC twice during a cycle. On... Jul 26 2024, 07:24 PM
Artfrombama
The #1 piston is at TDC twice during a cycle. O... Jul 26 2024, 07:27 PM Literati914
I think the manual calls for .006" for most... Jul 26 2024, 07:29 PM technicalninja If you've changed over to steel push rods, it... Jul 26 2024, 07:36 PM technicalninja It's .006 and or .008 depending on year.
For ... Jul 26 2024, 07:38 PM Literati914
.. Tight side of .016" intake/exhaust, IIRC ... Jul 26 2024, 08:13 PM technicalninja .016mm is .00062" or 6 tenths!
I'd ... Jul 26 2024, 08:19 PM 930cabman
.016mm is .00062" or 6 tenths!
I'd... Jul 27 2024, 05:05 AM Literati914
.16mm IS .0062" which is what you're th... Jul 26 2024, 08:21 PM  |
5 User(s) are reading this topic (5 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 16th September 2024 - 01:19 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.