 electrical help, masterswitch |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| butch |
 Sep 4 2003, 01:41 PM
Post
#1
|
|
Member  Group: Members Posts: 118 Joined: 12-March 03 From: San Jose Member No.: 415  |
Tiggr, also known as Julius, is set up for SCCA ITE, with includes a master cutout switch for the electrical. Master Brad did the installation.
So I had this little problem at the track which I circumvented by pulling the two wires off the number two poles on the masterswitch. I did not note which poles they came off. Brad told me how it was supposed to be wired, but me and my multimeter are having trouble figgerin it out. Mechanical engineer, I am. Electricity is magic. The wires go to 1) the wiring harness/ engine (call that "e") and 2) the 14 pin electrical block by the fire wall (call that "b"). I think wire "e" engine should connect to where the coil is shown on the attached diagram that came with the switch, and wire "b" electrical block should correspond to the ignition switch. Can anyone tell me if I am correct? Or am I gonna fry the whole system. Tanx. Butch Attached File(s) 
Master_Switch.pdf ( 25.53k )
Number of downloads: 133 |
   |
 
|
Posts in this topic
butch electrical help Sep 4 2003, 01:41 PM
Brad Roberts You need the two poles that have continuity thru t... Sep 4 2003, 11:23 PM
butch did that.
I'll call when I'm working on i... Sep 5 2003, 10:58 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 4th July 2024 - 12:52 PM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.