 ECU Connector Wires Loose, ...would this cause it to run rough? |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| vesnyder |
 Aug 6 2006, 08:44 PM
Post
#1
|
|
Senior Member  Group: Members Posts: 680 Joined: 14-April 05 From: Cleveland, OH Member No.: 3,933  |
As many of you have helped me over the past week with one of my cylinders that continues to miss I think I found the issue. I checked everything - from valves to injector - and nothing fixed the problem to I was wiggling the wiring to the ECU and the car stalled. After removing the ECU to check it, the white plug-in board was loose. I suspect that while I had the motor out, all the movement of the ECU made some of the connections loose. I reinserted each wire and fixed the wiring so it will not put any tension on the wire at the plug - and it seems to have fixed it! I drove the car all wekeend and it seemed to run fine (most of the time). I checked the compression on the cylinder and it still was low (90 vs 120+ on others), but does not seem to affect the driving.
|
   |
 
|
Posts in this topic
  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 26th December 2024 - 05:52 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.