 Door question..., checking curves.... |
|
|
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
|
| crash914 |
 Aug 23 2006, 05:55 AM
Post
#1
|
|
its a mystery to me  Group: Members Posts: 1,828 Joined: 17-March 03 From: Marriottsville, MD Member No.: 434 Region Association: MidAtlantic Region  |
all--
In checking the doors, I only had a 4 ft. straight edge... Front and rear align with the door edge, but there appears to be a curve to the door front to back. Is this the case? it is very slight and I am sure that I can blend it so it is smooth. This door had been hit and creased in the lower rear. plenty of filler later, the front and rear match up pretty good. i am also blending in flairs also. can someone run out and check with a 6 foot straight edge? many thanks.... see picture for before.... Attached image(s) 
|
   |
 
|
Posts in this topic
crash914 Door question... Aug 23 2006, 05:55 AM
URY914 After making several sets of fiberglass doors, I c... Aug 23 2006, 06:31 AM
thomasotten I have been getting mine ready for paint, so I hav... Aug 23 2006, 06:41 AM crash914 Thanks!
I saw the slight bow also and was won... Aug 23 2006, 04:25 PM  |
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 27th December 2024 - 03:50 AM |
Invision Power Board
v9.1.4 © 2024 IPS, Inc.