what did you do to your 914 today |
|
Porsche, and the Porsche crest are registered trademarks of Dr. Ing. h.c. F. Porsche AG.
This site is not affiliated with Porsche in any way. Its only purpose is to provide an online forum for car enthusiasts. All other trademarks are property of their respective owners. |
|
what did you do to your 914 today |
bbrock |
Dec 30 2017, 06:36 PM
Post
#9861
|
914 Guru Group: Members Posts: 5,269 Joined: 17-February 17 From: Montana Member No.: 20,845 Region Association: Rocky Mountains |
Stripped the undercoating off the floor. Me thinks I might have used too much elbow grease. (IMG:style_emoticons/default/shocked[1].gif)
|
914 Ranch |
Dec 31 2017, 12:52 PM
Post
#9862
|
Team Sharp where the 914 grow wings Group: Members Posts: 1,470 Joined: 29-January 16 From: TheNorth Shore Retreat. Deland Member No.: 19,611 Region Association: South East States |
^^^ I like it...
Carerror runs. Haven't driven her yet, throttle cable is wrapped. Maybe later today. UPDATE!!!! (IMG:style_emoticons/default/driving.gif) |
76-914 |
Dec 31 2017, 06:37 PM
Post
#9863
|
Repeat Offender & Resident Subaru Antagonist Group: Members Posts: 13,653 Joined: 23-January 09 From: Temecula, CA Member No.: 9,964 Region Association: Southern California |
Today I pulled down parts for my V8 car that where packed from my move 3 years ago. Lots of great stuff that I had not seen for some time. The covers for the rear trunk and cover for raised area above the hydraulic clutch cylinder on my 930 4 speed Trans. Back to work on this baby. Bob B Is that. V8 patch piece scavenged, fabricated or sold by someone. TIA, Kent (IMG:style_emoticons/default/beerchug.gif) |
burton73 |
Jan 1 2018, 11:03 AM
Post
#9864
|
burton73 Group: Members Posts: 3,719 Joined: 2-January 07 From: Los Angeles Member No.: 7,414 Region Association: Southern California |
Today I pulled down parts for my V8 car that where packed from my move 3 years ago. Lots of great stuff that I had not seen for some time. The covers for the rear trunk and cover for raised area above the hydraulic clutch cylinder on my 930 4 speed Trans. Back to work on this baby. Bob B Is that. V8 patch piece scavenged, fabricated or sold by someone. TIA, Kent (IMG:style_emoticons/default/beerchug.gif) The custom brackets I pulled out of a nice 74 car that I bought from Army Dude with the V8 set up with 930 trans. I cut the 14 x 14 opening and made a riser to clear the hump on the 930 flip trans and the hydraulic slave cylinder. I got trunk sheet metal so I could make the covers as they had to be bigger than the pieces cut out of original rear trunk (metal from Bruce Stone) I wanted a rear trunk and not just an open area where the trunk are on a stock car. I will mount my 5 lug Fucks with space saver over the lid if I can still put the top in. Bob B |
Cairo94507 |
Jan 1 2018, 11:08 AM
Post
#9865
|
Michael Group: Members Posts: 10,163 Joined: 1-November 08 From: Auburn, CA Member No.: 9,712 Region Association: Northern California |
Burton73 - Very nicely done. (IMG:style_emoticons/default/smilie_pokal.gif)
|
Larmo63 |
Jan 1 2018, 03:31 PM
Post
#9866
|
Advanced Member Group: Members Posts: 4,267 Joined: 3-March 14 From: San Clemente, Ca Member No.: 17,068 Region Association: Southern California |
I bought a nicely priced set of early bumpers recently, mainly for the rear blade. My son picked them up in L.A. for me and the rubber tops that came along with them were in great shape. Really a pleasant surprise. I installed the front top yesterday and painted the un-cracked grilles that came with the front bumper. The plastic chrome was pretty dead, so I shot some satin black on them....it's different?
|
Mueller |
Jan 1 2018, 03:41 PM
Post
#9867
|
914 Freak! Group: Members Posts: 17,150 Joined: 4-January 03 From: Antioch, CA Member No.: 87 Region Association: None |
|
Mike Bellis |
Jan 1 2018, 04:13 PM
Post
#9868
|
Resident Electrician Group: Members Posts: 8,347 Joined: 22-June 09 From: Midlothian TX Member No.: 10,496 Region Association: None |
Sold my Boxster S 6 speed transmission along with the LS engine adapter parts. Sold for what I paid for plus shipping so no money made, but no money lost which is nice for a change. Putting money right back to paypal and avoiding buying goods for the 914. Yes it went to a fellow 914World member. (IMG:style_emoticons/default/happy11.gif) |
euro911 |
Jan 2 2018, 12:56 AM
Post
#9869
|
Retired & living the dream. God help me if I wake up! Group: Members Posts: 8,860 Joined: 2-December 06 From: So.Cal. & No.AZ (USA) Member No.: 7,300 Region Association: Southern California |
I bought a nicely priced set of early bumpers recently, mainly for the rear blade. My son picked them up in L.A. for me and the rubber tops that came along with them were in great shape. Really a pleasant surprise. I installed the front top yesterday and painted the un-cracked grilles that came with the front bumper. The plastic chrome was pretty dead, so I shot some satin black on them....it's different? The black grilles look great, Goob ... adds some contrast (IMG:style_emoticons/default/cool_shades.gif)The 'BB' came with back-dated, dented gloss black bumpers when I acquired it. The PO also painted the [non-fog] grilles with the same gloss black, but they were prepped improperly and the paint was cracking off, so I blasted & painted the grilles silver for contrast. A few years later, I installed some small Pilot driving lights and the chrome bumpers from the '71, and reused the same grilles, but thought about repainting them black. (IMG:http://www.914world.com/bbs2/uploads/post-7300-1329958777.jpg) (IMG:http://www.914world.com/bbs2/uploads/post-7300-1331620241.jpg) I do have a few sets of restored fog/driving lights, and a couple pair of xlnt OEM chrome fog light grilles, so I'll probably install that setup when the more important tasks are completed. |
Porscheguy912 |
Jan 2 2018, 07:07 AM
Post
#9870
|
porscheguy912 Group: Members Posts: 46 Joined: 10-April 14 From: Summit, NJ Member No.: 17,236 Region Association: North East States |
|
michael7810 |
Jan 2 2018, 05:11 PM
Post
#9871
|
Senior Member Group: Members Posts: 1,082 Joined: 6-June 11 From: Scottsdale, AZ Member No.: 13,164 Region Association: Southwest Region |
|
Wyvern |
Jan 2 2018, 07:08 PM
Post
#9872
|
Member Group: Members Posts: 324 Joined: 7-October 15 From: San Francisco (East Bay) Member No.: 19,245 Region Association: Northern California |
I had a barely glowing "Generator Light".
Checked all the grounds, Tried a voltage regulator a friend gave me. didn't work, Same buddy gave me an alternator. Installed that & (IMG:style_emoticons/default/piratenanner.gif) all good to go. Ohhh and that is a kinda PITA job to do . |
914 Ranch |
Jan 3 2018, 05:30 PM
Post
#9873
|
Team Sharp where the 914 grow wings Group: Members Posts: 1,470 Joined: 29-January 16 From: TheNorth Shore Retreat. Deland Member No.: 19,611 Region Association: South East States |
|
J123young |
Jan 4 2018, 11:03 AM
Post
#9874
|
Member Group: Members Posts: 50 Joined: 1-February 17 From: Fenton, MO. Member No.: 20,801 Region Association: None |
15 degrees - it started (IMG:style_emoticons/default/piratenanner.gif) drove it around the block (IMG:style_emoticons/default/driving.gif) can't wait for Saturday's -3 degrees, probably stay inside (IMG:style_emoticons/default/popcorn[1].gif) Its cold here in the Lou ! |
SKL1 |
Jan 4 2018, 11:43 AM
Post
#9875
|
Senior Member Group: Members Posts: 1,649 Joined: 19-February 11 From: north Scottsdale Member No.: 12,732 Region Association: Upper MidWest |
|
Steve |
Jan 4 2018, 11:52 AM
Post
#9876
|
914 Guru Group: Members Posts: 5,778 Joined: 14-June 03 From: Orange County, CA Member No.: 822 Region Association: Southern California |
|
914 Ranch |
Jan 4 2018, 01:32 PM
Post
#9877
|
Team Sharp where the 914 grow wings Group: Members Posts: 1,470 Joined: 29-January 16 From: TheNorth Shore Retreat. Deland Member No.: 19,611 Region Association: South East States |
|
euro911 |
Jan 4 2018, 02:29 PM
Post
#9878
|
Retired & living the dream. God help me if I wake up! Group: Members Posts: 8,860 Joined: 2-December 06 From: So.Cal. & No.AZ (USA) Member No.: 7,300 Region Association: Southern California |
Will they make you wear a face mask, or goggles?
|
Mueller |
Jan 4 2018, 02:34 PM
Post
#9879
|
914 Freak! Group: Members Posts: 17,150 Joined: 4-January 03 From: Antioch, CA Member No.: 87 Region Association: None |
Drove both toys here in AZ yesterday- sure is nice here, not to rub it in for those in the rest of the country... Jealous of course! (IMG:style_emoticons/default/smile.gif) What is up with that cactus and the supports? |
matthepcat |
Jan 4 2018, 03:43 PM
Post
#9880
|
Meat Popsicle Group: Members Posts: 1,462 Joined: 13-December 09 From: Saratoga CA Member No.: 11,125 Region Association: Northern California |
Sold my Boxster S 6 speed transmission along with the LS engine adapter parts. Sold for what I paid for plus shipping so no money made, but no money lost which is nice for a change. Putting money right back to paypal and avoiding buying goods for the 914. Yes it went to a fellow 914World member. (IMG:style_emoticons/default/happy11.gif) http://www.914world.com/bbs2/index.php?showtopic=322090 Looks like a good chassis for those parts. (IMG:style_emoticons/default/aktion035.gif) |
Lo-Fi Version | Time is now: 10th January 2025 - 09:10 PM |
All rights reserved 914World.com © since 2002 |
914World.com is the fastest growing online 914 community! We have it all, classifieds, events, forums, vendors, parts, autocross, racing, technical articles, events calendar, newsletter, restoration, gallery, archives, history and more for your Porsche 914 ... |