'73 Resto & Suby 6 Conversion, or a primer on "How to convert your 914 to a Subaru 3.0" Options

[76-914]

What's it been? A year since I got Blackie running. I finally get it tuned to a daily driver status and should have been happy as a Lark then but what do I do? I sold the engine (w/90 hour's on the Hobbs) on the last Dawn Patrol GMR run. So I pulled the engine and began preparing Blackie for her transformation.


Before I go any further check out my Jack Stands. Min height 19.5", 12 ton and should hold up to a 6.7 quake or direct nuclear attack.


And out she comes.




One thing you have to love about these cars is that you can remove an interior in 15 minutes. 30 min's if you have a console. This was one shot before the interior is gutted.

and an hour later I'm scraping tar floorboards.

[76-914]

Thanks guys, good info. And I hope that I pulled off the turboencabulator that controls the mirror, too. (IMG:style_emoticons/default/biggrin.gif) I'll bet those wires are in the 35lb arena. I'll probably get $50 just for the scrap copper. (IMG:style_emoticons/default/biggrin.gif) I need to get those harness' attached to my "work station", spread out and disected. I'll need to build a frame for the engine but need to buy a tranny so I can mount the starter and on and on and on. It will be a long road. I need to hear it run and check out the electrical before I start stripping the wiring from the 914. Some days I wish I knew what I was doing. (IMG:style_emoticons/default/bootyshake.gif)